Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
®
Handylectric
MAINTENANCE
To keep your machine operating smoothly, it is essential that all bear-
ings and bushings be lubricated. Oiling moving parts is particularly
important where machine comes in contact with sand, grit and other
abrasive material.
DISCONNECT MACHINE FROM POWER SOURCE BE-
FORE PERFORMING MAINTENANCE ON MACHINE!
CABLE MAINTENENCE
To get maximum service from your cables,
be sure that they are clean and well oiled.
This not only
provides running lubrica-
tion but greatly extends the life of the
cables as well. Some users
cally pour oil directly into the drum. Then,
as the drum turns, the cables get complete
lubrication.
Our SNAKE OIL is ideally
suited for this purpose, since it not only
lubricates the cables, it deodorizes them
as well.
TROUBLE SHOOTING GUIDE (TABLE 3)
Problem
Cable kinks or breaks.
Cable tangles in drum.
Motor does not run.
Motor turns in one direction
but not other.
periodi-
Probable Cause
Operator forcing the cable.
Too much slack between machine and drain. Do not allow more than six inches between machine and drain.
Cable used in wrong size drain line.
Cable exposed to acid
Operator forcing the cable.
Machine run in reverse.
Trigger in neutral (off) position.
Reverse switch failure.
TO REMOVE MOTOR
1.
Pull the cable out of the drum.
2.
Loosen the three screws that hold the drum front and back to-
gether.
3.
Pull the drum front off of the machine.
4.
Loosen the two set screws in the beveled collar and remove both
the collar and the felt washer.
5.
Slide a flat head screw driver into the Hub Spindle and unscrew
the Left Hand locking screw from the drive shaft by turning it
clockwise.
6.
Unscrew the Hub Spindle from the Right Hand Drive Shaft by
rotating the drum back counter-clockwise. Note: The Hub Spin-
dle, Hub, and Drum Back remain as one unit. The thrust bearing
will slide freely.
7.
Reverse these instructions to re-assemble.
Solution
Do not force the cable. Let the cutter do the work.
A cable that is too large or too small in diameter for a line is more
likely to kink. (Consult Table 1—Cable Applications.)
Clean and oil cables regularly.
Do not force the cable. Let the cutter do the work.
Do not run machine in reverse to retract cable from drain.
Use reverse only if cable is caught in line.
Switch Trigger to either Forward or Reverse.
Replace reverse switch.
6
Publicidad
Tabla de contenido
