Scan; How To Edit The Scan List; Keypad Lock - Motorola XTN446 Manual De Instrucciones

1. To change the sensitivity, press the \button twice (the large
setting number will flash and the display shows the g icon and the
sensitivity type you are setting:
? - Microphone Gain
H - VOX with audio accessory
I - VOX without audio accessory
2. Use ] and [ to choose from the three available sensitivity
settings:
1 - If you speak loudly, or are in a noisy environment.
2 - Suitable for most applications.
3 - if you speak softly, or are in a quiet environment.
To disable VOX operation (VOX with audio accessories only), select 0

Scan

This feature allows you to monitor other channels. When the radio
detects activity, it stops scanning and locks in on the active channel.
This allows you to listen and talk to the person transmitting without
having to change channel.
When you activate scan, it will search each of your 8 channels using
the IE code you have selected for each channel. If you want to scan
without IE codes (carrier squelch scan), start scanning on a channel
which has the IE Code set to 0. You can also programme your radio to
scan specific channels by turning the other channels off in the scan
list.
1. To start scanning, briefly press J. The h icon shows in the
display and the large channel number begins to scroll through the
channels.
2. When channel activity is detected, scanning will be suspended, and
the display will show the number of the channel and the IE code.
3. You can then talk to the person on the new channel and IE code by
pressing M.
4. Scanning will resume after 5 seconds of inactivity on the channel.
5. If you press M while the radio is scanning, the radio will transmit
on the channel that was selected before you activated the scan
feature.
6. To stop scanning, briefly press J.
Scan Advance
This allows you to 'skip' a channel during scan, so you can continue
to check for other activity. When the radio locks on an active channel
during scan, press ] to resume scanning.
Nuisance Channel Delete
This feature temporarily deletes any 'nuisance' channels from your
scan list. When your radio locks on a 'nuisance' channel during scan,
press [ to temporarily remove the channel from the scan list. The
channel will be put back in the scan list when you exit scan.

How To Edit The Scan List

1. Press \ until h appears on the display. The channel number will
flash and the IE code number will be replaced with a flashing Y or n.
2. Use ] or [ to select the required channel.
3. Use J to select either Y to include the channel in the scan list or
n to exclude the channel from the scan list.
4. Press M briefly to exit.

Keypad Lock

This feature allows you to disable the keypad in the same way as
Manager Lock, but the keypad can be locked and unlocked more
easily.
10 English