Approved Applications - Falltech 7411 Manual De Instrucciones

mounted to a top beam flange, provided that the Free-Fall is restricted to
a maximum of 12'. When rigged for a Free-Fall greater than six feet,
your FallTech Beam Anchor must be used with a FallTech Ironman
series lanyard (7247, 7247Y, 8247 and 8247Y). Be sure to review the
Clear-Fall diagram and worksheet in section 2.9 of this manual.
This product meets the requirements of OSHA 1926.502 as well as
ANSI Z359.1-2007 and/or ANSI A10.32-2004. For further details on
these requirements, please go to
requirements. Copies of the ANSI standards are available at
www.asse.org in the e-standards store.

3.2: Approved Applications

Below are applications for which your
specifically suited. This list is not all-inclusive, but is intended to
anticipate the most common applications in which this product may be
used. If you have questions about whether this product is suitable for
your particular application, please consult a competent person or contact
FallTech for further advice.
Be sure to consult Section 5 of this instruction manual for details on
anchorage considerations, as the anchorage and its relationship to the
walking/working surface will be an important factor in determining
suitability and could contribute to the outcome of a fall event. Use of an
anchor point that is not properly rated could lead to a catastrophic failure
of your personal fall arrest system, which may result in serious injury or
death.
Overhead
Model #
Mount
7411 R
7490 R
7531 R
7530 R
7485 R
7486 R
7487 R
7488 R
7533 R
7534 R
7471 R
7489 R
7535 R
7710 R
R = Recommended
NR = Not Recommended
www.osha.gov
Foot-
Extended
level
Free-fall
Mount
NR NR
NR NR
NR NR
R R
NR NR
NR NR
NR NR
NR NR
R R
R R
NR NR
R R
R R
NR NR
14
to review the OSHA
FallTech Beam Anchor
Vertical
Mount
NR
NR
NR
NR
NR
NR
NR
NR
NR
NR
NR
R
R
NR
is
HLL/
Single
Multiple
User
User
R NR
R NR
R NR
R NR
R NR
R NR
R NR
R NR
R NR
R NR
R NR
R R
R R
R NR