Section 9: Maintenance And Storage; Section 10: Specifications; Mandatory Disclosures - Falltech 7411 Manual De Instrucciones

Section 9: Maintenance and Storage

The service life of your
factors: The environmental conditions of your working environment
along with proper care (specifically, maintenance and storage).
Keeping the
increase the service life and will ensure that the
proper working order in the event that you need it to arrest a fall. The
following steps should be taken periodically:
1. Using a damp rag and a mild soap and water solution, wipe
down the surface
contaminants. Ensure that the labels are legible at all times.
2. Use a damp rag to clean the surfaces of any connecting
hardware.
3. If there is an excessive build up of paint, oil, dirt tar or other
contaminants that cannot be removed, remove the
from service and have it replaced.
4. If any moving parts require lubrication, use a light application of
100% silicon spray. Do not use petroleum-based lubricants.
5. Store in a cool, dry location away from direct sunlight and where
it will not be exposed to chemical vapors.
6. This Beam Anchor
flat on a shelf.
7. Do not throw the
box, as this may cause damage.
Provided your
maintained, has not been involved in arresting a fall and is in serviceable
condition, it will be suitable for use. If your
repair or you are concerned about its condition, return it to the place of
purchase to arrange an inspection and/or repair through an authorized
service center. For further details, contact FallTech.

Section 10: Specifications

This section contains important information regarding the
performance and construction of this product. Pease read and be
familiar with this and all information contained in this instruction manual.

10.1: Mandatory Disclosures

This instruction manual addresses foreseeable hazards, uses and
applications. If you have questions about your application that are not
addressed in this document, contact FallTech for additional guidance.
FallTech Beam Anchor
Beam Anchor clean and free of contaminants will greatly
Beam Anchor
should be hung on a rack or a peg or stored
Beam Anchor
Beam Anchor
will depend on two
Beam Anchor
to remove soil and surface
into a pile or a locker or storage
passes inspection, has been properly
Beam Anchor
38
will be in
Beam Anchor
is in need of