Best WT32I Serie Instrucciones De Instalación página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. INSTALL ADAPTER/DAMPER (SINGLE BLOWER MODELS ONLY)
Plug hood power cord into the outlet.
Slide a 8" round metal duct over the adapter/damper. Use metal foil duct tape to seal
the joint.
10. INSTALL THE ADAPTER AND THE DAMPER (DUAL BLOWER MODEL ONLY)
In order to seal the joint between the adapter and the hood, cut to length the included
foam strip to cover the bottom flange of the 10" adapter. Peel off the paper covering
the sticky side of the foam strip and stick it on the flange, leaving a space for screw
notches (smallest ones on the adapter flange).
Place the adapter on top of the hood by aligning its screw
holes to those of the hood (1). Do not screw the adapter on.
Slide the damper over the adapter, placing its hinge parallel to
the range hood sides (2).
Remove the adapter and the damper from the top of the hood (keeping them together) and slide the
10" round metal duct over the adapter/damper. Secure the adapter/damper to the duct with 3 no. 8
sheet metal screws (not provided). Check to make sure damper opens and closes freely. Seal all joints
with metal foil duct tape to eliminate air leaks.
Plug hood power cord into the outlet.
Mount the assembled adapter/damper and duct to
the hood using 2 no. 8 x 3/8" sheet metal screws
(included).
See illustration at right for mounting screw locations.
NOTE: Duct and damper not shown in illustration to
ease understanding.
S
CREW HOLE LOCATION
1
HO0150
HJ0045
- 8 -
(CONT'D)
HJ0037
HO0149
D
AMPER HINGE
2
HJ0039
M
OUNTING SCREW LOCATION
HJ0046

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wt32i302sbWt32i362sbWt32i422sbWt32i482sb

Tabla de contenido