Stihl FS-KM Manual De Instrucciones página 12

USING THE CUTTING TOOLS
For an illustration of the various cutting
tools and instructions on proper
mounting see the chapter on "mounting
the cutting tools" in your owner's
manual.
Using the mowing heads
Do not use with mowing line longer than
the intended diameter. With a properly
mounted guard, the built-in cutter will
automatically adjust the line to its proper
length. Overly long lines can overload
the engine, resulting in damage to the
clutch mechanism and nearby parts.
FS-KM
A damaged clutch may cause a cutting
attachment to rotate at idle speed and
increase the risk of personal injury from
loss of control and from contact with the
cutting tool.
The STIHL SuperCut, AutoCut, TrimCut
and PolyCut mowing heads produce a
clean and tidy finish.
They are to be used only on brush-
cutters equipped with a limiter blade in
the deflector in order to keep the line at
the proper length (see "Parts and
Controls" chapter of this manual).
English / USA
If the lawn edges are planted with trees
or bordered by a fence etc., it is best to
use a nylon line head. It achieves a
"softer" cut with less risk of damaging
tree bark etc. than with the polymer
blades.
However, the polymer bladed STIHL
"PolyCut" produces a better cut if there
are no plants along the edge of the lawn.
Sharpening is not necessary and worn
grass cutting blades are easily replaced.
!
Warning!
To reduce the risk of serious injury,
never use wire or metal-reinforced line
or other material in place of the nylon
cutting lines. Pieces of wire could break
off and be thrown at high speed toward
the operator or bystanders.
STIHL SuperCut mowing head
Fresh line is advanced automatically.
Frayed line is replaced by a simple
adjustment (see instruction sheet
supplied with mowing head).
STIHL TrimCut mowing head
Frayed line is replaced by a simple
adjustment (see instruction sheet
supplied with mowing head).
11