Important; Step 2: Connect Water Inlet Hoses - Alliance Laundry Systems H264I Instalación Y Operación

Step 2:
Connect Water Inlet Hoses
NOTE: Refer to section on Water Supply
Requirements before connecting water inlet hoses.
Remove the four plain rubber washers from accessories
bag, and install them according to the illustration.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water mixing
valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately 1/4 turn
with pliers. DO NOT cross thread or overtighten
couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
800138
RUBBER WASHER
(Plain)
WATER SUPPLY
FAUCETS
WATER INLET
HOSES
RUBBER WASHER
(Plain)
INLET
HOSE
H091IE1B
COLD WATER
CONNECTION
HOT WATER
CONNECTION
WATER
MIXING
VALVE
H137IE3A
7