Programming The User Code - SentrySafe Fire-Safe Manual Del Dueño

Ocultar thumbs Ver también para Fire-Safe:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Programming information
Three code options:
FACTORY CODE:
The safe will ALWAYS unlock using this 5-digit code (found on the back of the owner's manual).
This code cannot be deleted.
USER CODE:
A 5-digit programmable code of your choosing that can be changed or deleted.
SECONDARY CODE:
A 5-digit programmable code of your choosing that can be changed or deleted. Can only
be programmed after a user code has been activated.
NOTE: The "C" key is a clear key. This can be used at any time to clear the system and return
to standby mode – unless you are in delay mode (3 consecutive invalid entries).

Programming the user code

NOTE: Only one user code can be programmed at a time.
NOTE: The electronic lock will NOT indicate that it has deleted the user code – please test
the code to make sure it has been deleted.
Programmable Electronic Lock
To ADD a user code:
Press the "P" key.
1
Enter the 5-digit factory code.
2
The light will flash green and then you will have five
3
seconds to enter your own 5-digit personal user code.
To DELETE a user code:
Press the "P" key.
1
Enter the 5-digit factory code.
2
Enter 0,0,0,0,0.
3
6

Publicidad

Tabla de contenido
loading

Tabla de contenido