Transmitter Compliance Statement; Maintenance - Overhead door SilentMax 4040 Manual Del Usuario

Settings Step 8:
Press in on tab
front of lens and open.
Figure 15 Install Lens Cover and Light Bulbs
A
Install two 60 Watt light bulbs (not included) into Light
Sockets:
• Rough service, 130 Volt bulbs are recommended.
B Install Emergency Release Kit ( GER-2 ) accessory,
if purchased.

Transmitter Compliance Statement

For Help, call 1-800-784-5028 or visit www.overheaddoor.com
I L B
NSTALL IGHT
60 Watts
maximum
at

MAINTENANCE

ULBS
A Monthly:
• Door springs and door hardware:
– Oil door roller, bearings, and hinges using silicone
lubricant or light oil.
Do not operate door automatically or manually if springs are
broken. Contact an Overhead Door Distributor for service or
call Customer Service at 1-800-784-5028 .
• Balance Door.
– Close door.
– Release Carriage Assembly from Rail Assembly
by pulling down on Emergency Release Knob.
– Raise door manually 3'- 4' and verify that door stays at
that position.See Check Step 2 on page 5.
When the door is 3' - 4' above the ground, the door
should stay open. Slight movement is acceptable. If the
door moves too much, contact an Overhead Door
Distributor for service or call Customer Service at
1-800-784-5028.
– Reattach Carriage Assembly to Rail Assembly:
a. Pull the Emergency Release Knob toward Power Head.
b. Close door.
• Contact Reverse Test.
– Perform Settings Step 7 on page 12.
If the door fails to reverse on contact with the board,even
after performing Setting Step 7 on page 12,contact an
Overhead Door Distributor for service or call Customer
Service at 1-800-784-5028 .
FCC AND IC CERTIFIED
All devices comply with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
WARNING
NOTE
WARNING
13