Silverline DIY Serie Manual Del Usuario página 10

GB
Operation
WARNING: Always use adequate protective equipment, including eye protection, respiratory and
hearing protection, when working with this tool.
Switching ON & OFF
1 . Check that the compressor is disconnected from all air tools or air lines and that the ON/OFF
Switch (21) is depressed
2. Connect the machine to the mains power supply
3. Pull the ON/OFF Switch upwards. This will start the compressor (Fig I)
4. Allow the compressor to build pressure; the tank pressure is displayed on the Compressed Air
Outlet Gauges (3 & 5). When the Tank (10) pressure reaches 8bar (116psi), the motor will stop
automatically
5. Press the ON/OFF Switch down to switch the compressor OFF (Fig I)
Connecting air tools
• Tools can be connected to the Quick Connectors (23 & 24) using a suitable air line fitted with a
corresponding ⁄ " and ⁄ " plugs
1 3
4 8
• Always ensure air tools are in the OFF position before connecting. Tools will be pressurised as
soon as the connections are made
• To connect an air tool, fit the air line to the tool, then push the bayonet fitting into the Quick
Connector outlet of the compressor
• Once connected, the output pressure can be adjusted. Turn the Pressure Regulator (4) clockwise
to increase pressure, and anti-clockwise to decrease pressure (Fig II). The line pressure is
displayed on the corresponding Compressed Air Outlet Gauge (3 or 5)
• Release the air line by pulling back the outer sheath of the high pressure outlet and
pulling the bayonet fitting out. Be aware that the air line and tool will hold residual air
pressure
Description Work to be carried out
Motor oil Check level
Change
Air filter Inspection
Cleaning
Fittings & fasteners Check, tighten & replace
if necessary
Valve maintenance Cleaning & clearance
adjustment
Tank Drain
10
Before each use After 1 month/every
20 hours
X
X
X
Adjusting line pressure
• The pressure of the air supplied to the tool (line pressure) can be adjusted using the Pressure
Regulator (4) . The line pressure is displayed on the corresponding Compressed Air Outlet Gauge
(3 or 5)
• Increase the line pressure by rotating the Pressure Regulator clockwise. To reduce the line
pressure, rotate the Pressure Regulator anti-clockwise
Accessories
A range of accessories—including hoses, air line filters and regulators, connectors, and air tools—is
available from your Silverline dealer .
Spare parts can be purchased from your Silverline dealer or online at www.toolsparesonline.
com .
Maintenance
WARNING: ALWAYS wear adequate personal protective equipment, including eye protection and
oil-resistant gloves, when carrying out maintenance on this compressor. ALWAYS ensure proper
ventilation .
WARNING: If oil is removed during maintenance, fill into suitable sealed containers and dispose of
according to laws and regulations.
WARNING: ALWAYS switch the compressor OFF and wait until all components have completely
cooled before cleaning or carrying out any maintenance (with the exception of oil removal; refer to
'Motor oil maintenance').
Note: The maintenance schedule should be adjusted according to use and environment . If the
compressor is used frequently, and/or if it is used in harsher environments, shorter maintenance
intervals are required .
WARNING: Always remove the plug from the mains power supply before carrying out any
maintenance/cleaning .
• DO NOT attempt to perform any maintenance when the air tank is pressurised
Every 3 months/50 Every 6 months/100
hours hours
X
X
Every 12 months/300
hours
X
X
X (requires qualified
technician)