Cleaning And Maintenance; In The Event Of Problems - Beurer MG 135 Instrucciones Para El Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
The massage should feel pleasant and relaxing at all times. If the massage is painful or uncomfortable, stop
the massage or change your position or the contact pressure.
• Do not trap or squeeze any part of your body, especially feet, hands and fingers, between the rotating
massage heads and their mountings in the device.
• Switch on the massager using the
again to change the massage direction of the massage heads. Press the
heat function.
• Press and hold the
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer
can over-stimulate the muscles and cause tension instead of relaxation.
• The device features an automatic switch-off function, which is set to the maximum operating duration
of 15 minutes.
Back massage:
upper back area

10. Cleaning and maintenance

CLEANING
WARNING
• Before cleaning disconnect the power supply unit from the mains socket and disconnect it from the
device.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device
or accessories.
• Small marks can be removed using a cloth or damp sponge, and some liquid delicate laundry
detergent where necessary. Do not use any solvent-based cleaning products.
• Do not use the device again until it is completely dry.
• The removable cover can be machine-washable at 30°C. Please note the symbols for care and
cleaning on the label sewn into the cover.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Note
• You can use any standard size cover (40 x 40 cm) for the massager.

11. In the event of problems

Problem
Massage heads rotating
at reduced speed.
Massage heads not
moving.
button. The massage heads will start to rotate. Press the
button to turn off the massager.
Back massage:
lower back area (lumbar)
Cause
The load on the massage
heads is too great.
Appliance not connected to
the power supply.
Leg massage
Remedy
Release the massage heads.
Connect the mains part and switch on the
device.
15
button to activate the light and
button

Publicidad

Tabla de contenido
loading

Tabla de contenido