Charging Procedure - GreenWorks 2600702 El Manual Del Propietario

CHARGER PROCEDURE
C
2
False Defect Note:
from the charger for 1 minute, then reinsert. If the status LED indicates normal than the
battery pack is good. If the status LED is still blinking, remove the battery pack and unplug
the charger. Wait 1 minute and plug the charger back in and reinsert the battery pack. If the
status LED indicates normal than the battery pack is good. If the status LED is still blinking
then the battery pack is defective and needs to be replaced.
within 2 hours. If the indictor shows charging, that means the battery is good. After 2 hours,
please pull out the battery and also pull out the AC power plug of the charger for 1 miniute,
and then insert the AC power plug and the battery again. If the indictor shows charging, that
means the battery is good. If not, the battery needs to be changed.
1
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
3
15
REDR ED
RED GREEN
ORANGE
RED
NO
RED
LIGHT
RED
RED
BLINKING