Publicidad
Idiomas disponibles
Idiomas disponibles
Heating
Fig. 11
•
Leave the ignition-/air vent 24 mm open (fig. 11) when the
wood has caught fire properly and is burning well.
•
Close the door.
•
You can then regulate the rate of combustion to give the heat
you want by adjusting the air vent.
•
Check that the afterburning (secondary combustion) starts.
This is best indicated by yellow, flickering flames in front of
the holes under the baffle.
Adding firewood
Stoke the stove frequently but only add small amounts of fuel at
a time. If the stove is filled too full, the heat created may cause
extreme stress in the chimney. Add fuel to the fire in moderation.
Avoid smouldering fires as this produces the most pollution.
The fire is best when it is burning well and the smoke from the
chimney is almost invisible.
•
Refuelling on to a low fire bed: If there is insufficent burning
material in the firebed to light a new fuel charge, excessive
smoke emission can occur. Refilling must be carried out
onto a sufficient quantity of glowing embers and ash that
new fuel charge will ignite in a reasonable period. If there
are too few embers in the fire bed, add suitable kindling to
prevent excessive smoke.
•
Fuel overloading: The maximum amount of fuel specified
in this manual should not be exceeded, overloading can
cause exess smoke
•
Operating with door left open: Operation with the door open
can cause excess smoke. This appliance must not be operated
with the appliance door left open except as directed in the
instructions.
•
Dampers left open: Operation with the air controls or
apploance dampers can excess smoke. The appliance must
not be operated with air controls, appliance dampers or door
left open exept as directed in the instructions.
4.9 Danger of overheating
The fireplace must never be used in a manner that
causes overheating
Overheating occurs when there is too much fuel and/or too much
air so that too much heat develops. A sure sign of overheating is
when parts of the fireplace glow red. If this happens, reduce the
air vent opening immediately.
Seek professional advice if you suspect that the chimney is not
drawing properly (too much/too little draught). For further
information, see «4.0 Installation» (Chimney and flue pipe).
5.0 Daily use
Odours when using the fireplace for the first time
When the fireplace is used for the first time, it may emit an
irritating gas which may smell slightly. This happens because
the paint dries.The gas is not toxic but the room should be
thoroughly ventilated. Let the fire burn with a high draught until
all traces of the gas have disappeared and no smoke or odours
can be detected.
5.1 Operation
Heating advice
NB: Logs that have been stored outdoors or in a cold room should
be brought indoors 24 hours before use to bring them up to room
temperature.
There are various ways of heating the stove but it is always
important to be careful about what you put in the stove. See the
section on "Wood quality".
Wood quality
By quality wood we mean most well-known types of wood such
as birch, spruce and pine.
The logs should be dried so that the moisture content is no more
than 20%.
To achieve this, the logs should be cut during the late winter. They
should be split and stacked in a way that ensures good ventilation.
The wood stacks should be covered to protect the logs from rain.
The logs should be brought indoors during early autumn and
stacked/stored for use in the coming winter.
Be especially careful never to use the following materials as fuel
in your fireplace:
•
Household rubbish, plastic bags, etc.
•
Painted or impregnated timber (which is extremely toxic).
•
Laminated wooden planks.
•
Driftwood
These may harm the product and are also pollutants.
NB: Never use petrol, paraffin, methylated spirit or similar liquids
to light the fire. You may cause serious injury to yourself and
damage to the product.
Wood consumption
Use of wood, with nominal heat emission: Approx. 1,6 kg/h.
Another important factor for proper fuel consumption is that
the logs are the correct size. The size of the logs should be:
Kindling:
Length: 23-33 cm
Diameter: 2 - 5 cm
Amount per fire: 6 - 8 pieces
Daily use
Firewood (split logs):
Length: 23 - 33 cm
Diameter: Approx. 8 cm
Intervals for adding wood: Approximately every 45 minutes
Size of the fire: 1,2 kg
Amount per load: 2 pieces
Nominal heat emission is achieved when the air vent is open
approximately 57 %.
Maximum use
Maximum load: 2,9 kg/h (maximum 3 pieces/2,2 kg per load).
ENGLISH
13
Publicidad
Capítulos
