STEINEL FL300W Instrucciones De Instalación página 5

Wall mounting - double-gang
weatherproof box
A double-gang weatherproof box is
recommended for exterior wall mount
applications. The crossbar is typically not
used and the backplate mounts directly to
a gasket and weatherproof junction box.
Materials needed (included):
- One standard backplate
- Two mounting screws
- Two 1/2" Phillips screws
Materials needed (purchased separately):
- One weatherproof double-gang junction
box with gasket (mounting screw holes
are 5.25" apart)
Wall mounting - weatherproof
box (other than double-gang)
If mounting to an existing box other than
a double-gang weatherproof box, the
provided crossbar may be needed.
Materials needed (included):
- One standard backplate
- One crossbar (mounting screw holes are
3.75" apart
- Two mounting screws
- Two washers, 2 nuts
- Two 1/2" Phillips screws
Materials needed (purchase separately):
- One weatherproof junction box (other
than double-gang)
- Weatherproof silicone caulk
• Remove housing backplate.
• Confirm that plug on top of unit is
snapped into place.
• Align slots of crossbar with screw holes
of existing box and secure with screws.
(Note: crossbar may not be required for
certain applications.)
• Remove sensor's backplate.
• Confirm that plug on top of unit is
snapped into place.
• Line up backplate and gasket over
double-gang waterproof box.
• Feed wires through center hole of
backplate. Verify that holes in the lower
left and upper right hand corners of
backplate line up with holes in junction
box.
• Connect wires from sensor to
corresponding wires in junction box.
(See Wiring.)
• Fasten backplate and gasket to
junction box with mounting screws.
• Line up sensor over backplate and
mount on top lip of backplate. Fasten
unit to backplate using two Phillips
screws.
• Adjust crossbar to a horizontal
position and line up pre-drilled holes
in backplate. Tighten center screws on
crossbar to lock into position.
• Feed wires through center hole of the
backplate.
• Connect wires from sensor to
corresponding wires in junction box.
(See Wiring.)
• Fasten backplate to crossbar using two
washers and nuts and tighten to assure
backplate is firmly in place.
• Line up sensor over backplate and
mount the top lip of sensor to top lip of
backplate. Fasten sensor to backplate
using two Phillips screws (provided).
• If needed, apply weatherproof silicone
caulk around back edge of backplate
to assure watertight fit to junction box.
www.steinel.net
5
(800) 852-4343