Getting Started; Installing Backup Batteries - Clarity XL50 Guia Del Usuario

GETTING STARTED

There are five initial steps involved in setting up
your XL50
1. Insert four AA alkaline batteries for back-up in case of
AC power outage. See below.
2. Decide if you want the phone to sit on a desk or hang
on the wall.
3. Connect the telephone components. Pages 15-16.
4. Program up to 10 telephone numbers to call
with the press of a memory button. See Page 18.
5. Set up Notification Options. See Page 20.
Installing the Backup Batteries
If there is a power outage, the XL50 will operate for up
to 48 hours with four AA alkaline backup batteries (not
included). If the phone is not in use, the batteries will stay
charged for several months. See Figure 1.
1
To install new batteries:
2
1. Slide open the battery compartment cover on the
Figure 1
bottom of the telephone. To open the battery
compartment, use a pen or similar fine point
instrument to press into small opening below the
compartment door. This opening is pointed out with
the #2 in Figure 1.
2. Install four fresh batteries. Be sure to observe battery
polarity as imprinted on the base of the compartment.
The battery indicator on the top panel will light up if
the batteries are running low.
The phone operates as a regular phone if there is no
power or battery. Certain functions of the phone do
require power however. If no power is being supplied to
the phone, it will have no indicator lights, the loud ringer
will be disabled, there will be no amplification, and the
lighted keypad will not be lit.
14
GETTING STARTED
Connecting your Telephone
1. Carefully remove your telephone from its box. If there
is any visible damage, do not attempt to operate this
equipment. Return it to the place of purchase.
2. Check to be sure that you have all items that come
with your XL50 telephone. You should have a Handset,
Base Unit, AC Adapter, Mounting Bracket, Handset
Line Cord, and Telephone Line Cord.
Choosing a Location
• The XL50 requires a modular phone jack and a
standard 120 Volt outlet for operation.
• The unit should be located in an area where it is easy
to see the visual display and lighted ringer.
• Choose a location that is out of the way of normal
activities.
• The unit can be used as a desk top phone or wall
mount phone.
WARNING:
Always connect the AC adapter to the
phone before you connect it to the AC power. When you
finish, disconnect the AC power before you disconnect it
from the telephone.
Desk Mounting Instructions
Follow these instructions to place the phone on a desk or
table top using the supplied bracket.
1. Plug one end of the long flat telephone line cord into
the jack marked LINE located on the back of the
telephone. Plug the other end into the telephone wall
jack. See Figure 2
2. Insert the plug of the AC adapter into the jack marked
DC 9V located on the back of the base unit. Then plug
AC adapter into wall outlet. See Figure 2.
E
N
G
L
I
S
H
1
2
Figure 2
15