BRAND Titrette Instrucciones De Manejo página 79

Design change from January 2012
4. Installing the titrating tube
a.
e.
5. Installing the top part of the housing
a.
9974 69
The connection between the titrating tube and the valve
block was changed as of January 2012.
Therefore, when ordering these replacement parts, note the
distance between the dispensing duct and recirculation duct
on the valve block. If there is no gap between the two ducts,
always replace the titrating tube at the same time the dis-
pensing cylinder with valve block is replaced (Accessories/
spare parts, p. 86).
(Note the design changes from 2012, see Intensive clean-
ing, p. 79). Installing the cleaned or new titrating tube:
a.
Slide the titrating tube on approx. 5 mm.
b.
Push the titrating tube housing all the way up.
c.
Then slide the titrating tube all the way in.
d.
Slide the titrating tube housing down to lock it into
place.
e.
Pull up the valve lever to the 'Recirculate' position and
press it in firmly.
a.
Check that the piston rod locking mechanism has been
pulled out.
12 Cleaning
79
Operating manual