Decimal Places (Dp Mode) - BRAND Titrette Instrucciones De Manejo

11 Additional functions

11.4 Decimal places (dP mode)

In dP mode, the display can be set to show 2 or 3 decimal places (factory default setting is 2 decimal
places).
For technical reasons, titration volumes over 20.00 ml can only be displayed with 2 decimal places.
1. Entering dP mode
a.
b.
2. Changing decimal places
a.
3. Confirming input
a.
Press the CLEAR button to confirm the input of the desired decimal place format.
74
Operating manual
NOTICE
a.
With the instrument powered on, press and hold the
> 3 s
CLEAR button for more than 3 seconds until the follow-
ing modes are repeatedly shown one after another in
the display:
CAL — GLP — APO — dP
b.
When dP appears in the display, release the CLEAR but-
ton. The input symbol blinks and the factory setting ap-
pears.
a.
Press the Pause button to select a display with 3 deci-
mal places. (Pressing the button again converts the dis-
play back to 2 decimal places.)
9974 69