Operating Elements - Abicor Binzel ABITIG Little Serie Instructivo De Servicio

®
ABITIG Little

5 Operating elements

5.1 2-cycle function trigger
6 Operation
NOTE
• As the TIG welding torches are integrated into a welding system, the
operating instructions of the welding components, such as the welding
power supply, must be observed during operation.
Using a standard welding torch, the two-cycle mode of the trigger can be
activated.
1 Press the Single function trigger on the handle and keep it depressed =
welding is started.
2 Release the trigger = welding is stopped.
DANGER
Health hazards caused by radioactive substances
Radioactive substances are released during welding and sharpening of
thorium-tungsten electrodes.
• Use a suitable extractor unit.
WARNING
Electric shock
Equipment parts are energized in the enterprise.
• Do not reach into the danger zone.
1 Open the shielding gas cylinder.
2 Start the welding process.
3 After ignition, hold the welding arc tight to the edge of the material to be
welded until a molten pool is formed.
4 Move the torch uniformly over the entire seam length.
5 Stop the welding process.
6 After switching off, hold the torch over the end position for a few seconds.
This allows the molten pool to solidify without atmospheric interference
under the protection of the gas which is continuing to flow.
5 Operating elements
EN - 11