Putting Into Operation; Overview Of Connections And Operating Elements En - Abicor Binzel ABIDRIVE CW Instructivo De Servicio

TIG cold wire feeder

5 Putting into operation

Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• The system may only be installed and put into operation by authorized personnel
5.1 Installation
Risk of injury due to tilting of ABIDRIVE CW
Risk of crushing of body parts due to
• When installing the ABIDRIVE CW the tilting stability is guaranteed up to an angle of 15°. Do not
• Install the ABIDRIVE CW ensuring a stable position and secure it.
5.2 Overview of connections and operating elements
1 2
18
17
16
1 Power supply
2 Power connection X4 Intermediate cable assembly
3 Plug socket (to X2)
4 Power supply connection X2
5 Control lead plug X3 Intermediate cable assembly
6 Wire feeder dial
Fig. 4 Overview of connections and operating elements
DANGER
(in Germany see TRBS 1203).
WARNING
exceed the angle of 15°.
3 4
15
7 Timer / Feed dial
8 Program selection switch
9 Display
10 Timer / Pause dial
11 Central plug
12 Socket of control lead X1
5 6 7
14 13
13 Coolant return
14 Coolant supply
15 Gas connection
16 Mains plug
17 Power switch
18 Gas safety valve (T 0.63)
5 Putting into operation
8
9
10
11
12
EN - 9