Electric Connections - RIB DUKE 24V 110 Manual Del Usuario

EMERGENCY RELEASE
To be carried out after having disconnected the power supply to the motor.
In order to carry out the manual operation of the gate leaf the followings must be checked:
- That the gate is endowed with appropriate handles;
- That these appropriate handles are placed so to avoid safety risks for the operator;
- That the physical effort necessary to move the gate leaf should not be higher than 225
N, for doors/gates for private dwellings, and, 390N for doors/gates for commercial and
industrial sites ( values indicated in 5.3.5 of the EN 12453 norm) .
In the case of a power cut, the gate can be opened manually by releasing the lock on the
operating lever to allow the gate to move freely (Fig. 8).
IMPORTANT: Please make sure that the leaves stop against the
mechanical stoppers inside the operator before
they reached the ground mechanical stopper. In not
adjusted, unblocking will be impossible.

ELECTRIC CONNECTIONS

ANTENNA
24Vdc 0,8A ± 15% for AUTOTEST SAFETY STRIPS
PEDESTRIAN
STEP BY STEP
PHOTOCELLS
COMMON
SAFETY STRIPS
R=2,2K 1/4W
LED
COMMON
CLOSE
OPEN
STOP
ANTENNA
BRAIDING
MAINTENANCE
To be undertaken by specialized staff after disconnecting power supply.
Make certain that moving parts located inside the box are greased once a year, and check
the force transmitted through the drive to the gate.
In the event that the need for servicing or repairs should arise, the speed reducer can be
removed from the box without taking down the gate.
- Lift the cover from the box, isolate the motor from the power supply by disconnecting
the cable, then remove the curved lever: the gate can now swing freely.
- Then unscrew the for nuts that fix the motor.
T2 24V D CRX
24Vdc 0,8A ± 15% for ACCESSORY SUPPLY
BLINKER
24Vdc 20W
ELECTRIC
POWER SUPPLY
LOCK
230Vac 50 Hz
31
31
code AC02027
FUSE
T 2 A
TRANSFORMER
M1
M2
G
B