Transport; Storage; Frost Protection; Care And Service - Kärcher PCL 4 Manual Del Usuario

Water volume regulation valve
Note
The volume of water emitted by the device
through the nozzles can be adjusted using
the water volume regulation valve to suit
the cleaning task.
1. Pull the valve lever backwards to in-
crease the water volume.
2. Push the valve lever forwards to de-
crease the water volume or close the
valve completely.
Illustration H
Cleaning wooden surfaces
Use the brush for wooden floor coatings for
cleaning wooden surfaces.
Note
Always clean wooden surfaces in the direc-
tion of the grain. Always clean along the
floorboards or wooden elements and down
the slope.
1. Guide the device slowly over the sur-
face.
Illustration I
Cleaning stone surfaces
Use the brush for stone coverings for clean-
ing stone surfaces (not included in the
scope of delivery - see the Accessories and
spare parts chapter for sources).
Note
Remove any loose elements, such as loose
gravel in exposed aggregate concrete pan-
els, before cleaning.
1. Guide the device slowly over the sur-
face.
Storing the device
Illustration J
The device can be stored hanging on a wall
hook. You can also alternatively place the
device on the parking edge of the spray
guard. Take care to ensure that the device
does not stand on the brushes to prevent
damage to the bristles.
1. Disconnect the connections.
2. Empty the device (see "Frost protec-
tion").
3. Clean the device (see "Cleaning").
14
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during

storage.

Frost protection

ATTENTION
Danger of frost
Incompletely emptied devices can be de-
stroyed by frost.
Completely empty the device and accesso-
ries.
Protect the device from frost.
1. Store the device in a frost-protected
place.
Note
If frost-free storage is not possible:
2. Open the water volume regulation valve
completely.
3. Stand the device upright and allow it to
drain.
Illustration K

Care and service

Replacing the brushes
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Note
Always replace both brushes at the same
time. The brushes must be replaced when
the gearbox housing touches the ground
while cleaning the surface without exerting
pressure on the device.
English

Transport

Storage