Symbols On The Device; Installation; Initial Startup; Operation - Kärcher PCL 4 Manual Del Usuario

Symbols on the device

Danger of electric shock. Un-
plug the mains plug if the mains
cable is damaged!
Risk of injury due to flaying ob-
jects!
Risk of injury. Keep other per-
sons away!
Risk of eye and hearing dam-
age. Wear safety goggles and
hearing protection!
Risk of damage. Do not clean
the device with a hose or high-
pressure water jet!
Risk of damage. Do not subject
the device to rain!
Risk of burns from hot surfaces!

Installation

Note
The handle is installed only once. The han-
dle halves may not be separated again af-
ter installation. Take care to ensure that the
water hose and the mains cable are not
crushed during installation.
1. Plug the handle sections together. The
pipe latches audibly into place.
Illustration B
2. Press the water hose and then the
mains cable into the cable channel from
the top to the bottom (starting at the
hand grip).
Illustration C
3. Press any protruding cable and water
hose firmly into the brush head casing.
Illustration D
The mains cable and water hose must not
protrude out of the device during operation!

Initial startup

1. Close the water volume regulation valve.
Illustration H
2. Connect the water hose to the device.
The coupling must audibly engage.
3. Secure the water hose to the hand grip
using Velcro tape to provide strain relief.
Illustration E
4. Connect the water hose to the water tap
and open the water tap. Please observe
the maximum water pressure (see
"Technical data").
5. Connect the mains cable to a suitable
extension cable labelled as conforming
to protection class IPX4. Please be sure
to observe the safety instructions.
Correct handling of the brushes
Note
Use only the brushes suitable for the sur-
face to be cleaned.
Observe the following instructions for cor-
rect use of the brushes.
1. Position the brushes evenly on the sur-
face to be cleaned.
Illustration F
2. Guide the brushes over the surface with
light pressure.
Switching on the device
Note
You must unlock the power switch in order
to start the device. The specified sequence
must be adhered to
1. Press the unlocking button.
Illustration G
2. Press the power switch.
The device starts up.
3. Release the power switch.
The device stops.
English

Operation

13