Troubleshooting - Festo DNCE Serie Instrucciones De Utilizacion

DNCE
11

Troubleshooting

Malfunction
Possible cause
Backlash too Wear
great
( 8 Mainten-
ance and care)
Squeaking Distortions
noises or
vibrations
Incorrect regulator settings
Running noises of the spindle support
(with strokes ≥ 300 mm and high posi-
tioning speeds)
Piston rod Jamming in the mechanical end position
does not move (e. g. after reference travel with excess-
ive speed or prohibited travel to the end
position during operation)
Loads too high
Tension of toothed belt in parallel kit
too high
Ambient temperature too low
(increased breakaway torque in initial
run due to increasing viscosity of the
lubricants in the spindle system)
Tab. 6
28
Remedy
Send DNCE to Festo for repair
Mount DNCE free of stress
(evenness of bearing surface: ≤ 0.2 mm)
Lubricate piston rod
( 8 Maintenance and care)
Modify speed of travel
Modify the regulator parameters
(only with servo motors)
No impairment of function
– To release a jam manually:
1. Switch off the power supply,
2. Remove motor and coupling
housing,
3. Turn drive shaft to release it
– Reduce speed for reference travel
– Provide software end positions, at
least 0.25 mm away from the
mechanical end positions (stops)
– Reduce load mass
– Reduce travel speed
– Send DNCE to Festo for repair
Reduce tension of toothed belt
( Parallel kit assembly instructions)
– Reduce load mass
– Reduce travel speed
– If necessary, allow higher current
with servo motors (
instructions for the motor)
– Adjust ambient temperature
Festo – DNCE – 1109e English
Operating