Removing Belt - Panasonic MC-UG693 Instrucciones De Operación

Carpet/Bare Floor Selector
Sélecteur tapis/plancher
Selector de pisos con
alfombra y sin alfombra
To Carpet Position
Position tapis
Para aspirar sobre
una alfombra
Nozzle Cover
Couvercle
de la base
Cubierta de la boquilla
Agitator Cover
Couvercle de l'agitateur
Cubierta del agitador
Agitator Cover
Couvercle de l'agitateur
Cubierta del agitador
Agitator
Agitateur
Agitador
Belt
Courroie
Correa

Removing Belt

Latches
Loquets
Pestillos
Furniture
Guard
Retainer
Retenue de
pare-chocs
Sujetador del
protector
de meubles
Post
Borne
Pestaña
Latches
Languettes
Pestillos
➢ ➢ Disconnect power cord from
electrical outlet.
➢ ➢ Place the carpet/bare floor selector
in the carpet position.
➢ ➢ Slide latches outward and remove
nozzle cover.
➢ ➢ Unfasten the furniture guard
retainers from the posts on both
sides of the agitator cover.
➢ ➢ Depress tabs on rear of agitator
cover and rotate forward to release
from the nozzle body.
➢ ➢ The light bulb socket assembly
does not have to be removed. Lay
the agitator cover over to the side
out of the way.
➢ ➢ Position hands on the agitator. If the
belt is still attached to the agitator,
there will be tension on the agitator.
➢ ➢ Carefully lift the right end of the
agitator and then the left end.
Note: It may be necessary to pull the
edge of the furniture guard out of the
way to allow the ends of the agitator to
be removed easily.
➢ ➢ Remove the belt from the motor
drive shaft.
WARNING
Personal Injury Hazard
Be careful when removing the agitator
as the belt tension is high. Failure to
do so could result in personal injury
from the agitator releasing quickly
and snapping away.
- 50 -