Removing Belt - Panasonic MC-CG917 Instrucciones De Operación

Tabs
Pestaña
Agitator Cover
Couvercle de l'agitateur
Cubierta del agitador
Agitator Support
Support de l'agitateur
Soportes del agitador

Removing Belt

Languettes
Base
Base
Base
- 44 -
Disconnect vacuum cleaner from
electrical outlet.
Check and remove hair, string and
lint build-up frequently in the POWER
NOZZLE brush and brush support
areas.
If build-up becomes excessive,
disconnect POWER NOZZLE from
wand and follow the steps below.
Turn POWER NOZZLE over.
Unscrew the two (2) POWER
NOZZLE cover screws.
Turn POWER NOZZLE right side up.
Press handle release pedal and
lower the swivel.
To remove cover, grasp the sides and
pull out.
Tilt cover forward from back until
front snaps free.
Depress tabs on rear of agitator
cover and rotate forward to release
from the POWER NOZZLE base.
Lift agitator assembly out .
Remove worn belt.
Agitator Assembly
Belt Pulley
End Cap
Brush Unit
End
Cap