Removing Belt; Agitator Assembly - Panasonic MC-CG985 Instrucciones De Operación

Tabs
Pestaña
Agitator Cover
Couvercle de l'agitateur
Cubierta del agitador
Agitator Support
Support de l'agitateur
Soportes del agitador

Removing Belt

Languettes
Base
Base
Base
- 48 -
➢ ➢ Disconnect vacuum cleaner from
electrical outlet.
➢ ➢ Check and remove hair, string and
lint build-up frequently in the POWER
NOZZLE brush and brush support
areas.
➢ ➢ If build-up becomes excessive,
disconnect POWER NOZZLE from
wand and follow the steps below.
➢ ➢ Turn POWER NOZZLE over.
➢ ➢ Unscrew the two (2) POWER
NOZZLE cover screws.
➢ ➢ Turn POWER NOZZLE right side up.
➢ ➢ Press handle release pedal and
lower the swivel.
➢ ➢ To remove cover, grasp the sides and
pull out.
➢ ➢ Tilt cover forward from back until
front snaps free.
➢ ➢ Depress tabs on rear of agitator
cover and rotate forward to release
from the POWER NOZZLE base.
➢ ➢ Lift agitator assembly out .
➢ ➢ Remove worn belt.

Agitator Assembly

End Cap
Brush Unit
Belt Pulley
End
Cap