Putting Into Operation; Filling The Tank - Air-O-Swiss AOS U200 Manual De Instrucciones

Putting into operation

• Remove the plastic cover of the adapter and insert the
country specific plug (13).
• Do not place the humidifier directly next to a heating
vent or on a floor with floor heating. The moisture of
the mist can damage the floor surface (6) (see Safety
Instructions).
• The unit should be placed in an elevated position (7),
e.g. on a table, chest, etc. at least 3 ft off the floor.
• The mist outlet must not be pointed directly at plants,
furniture, or other objects (14). Keep distance of at
least 20 inches (50cm).
• Soak the demineralization cartridge in a bowl of water
for at least 24 hours before using it. The granules have
to absorb water to reach maximum performance. If the
cartridge is soaked in the tank, make sure to exchange
the water and empty the water from the base before
using the humidifier.
• On average the demineralization cartridge should be
replaced every 2 – 3 months. This interval can be
shorter or longer depending on the hardness of your
water. The cartridge must be exchanged at the latest
after 6 months or the unit will not reach its full
performance capability. See «Replacement of the
demineralization cartridge».
• Read the instructions under «Filling the Tank» for filling
the water tank.
• Place the water tank onto the base (17).
• Connect the adapter to the unit and the electrical
socket and switch on the unit using the rotary switch
(18).
• The appliance will reach full capacity about 10 to
15 minutes after being switched on.
• Make sure that the power cord is not pinched
anywhere. Do not operate the appliance if the cord
is damaged (2).

Filling the tank

Always switch off the appliance before removing
the water tank. Do not reach inside the nebulizer
space while the appliance is running!
To protect health safety and proper humidi-
fier function use only clean, contamination-
free, cold, fresh tap water in your humidifier. If
your water source is contaminated or if you are
uncertain of its safety use distilled water.
Do not operate the appliance when the water tank is empty!
When the water reaches the minimum level, the unit swit-
ches off automatically.
• Make sure that there are no foreign objects inside the
water tank.
• Remove the water tank cap from the tank (15). Fill the
tank with clean, cold tap water (16). Close the cap of
the water tank securely! Place the water tank onto the
base (17). Do not add any additives to the water!
• Connect the adapter to the unit and the electrical
socket and switch on the unit using the rotary switch
(18). The empty indicator light may stay illuminated for
some seconds until the base is filled with water.
13
14
15
en
9