10
IS...-X Models
Leveling the weighing platforms using the level indicator:
Models IS150IGG-HX, IS300IGG-HX
– Remove the load plate
– Loosen the locknuts on the leveling feet using an SW 17 open-end wrench (spanner).
– Use an Allen wrench (Allen key) to retract or extend the leveling feet.
§ At the place of installation, level the weighing platform using the leveling feet so
that the air bubble is centered within the circle of the level indicator.
Make sure all 4 feet rest on the work surface so that during operation, the load will
distributed evenly over the weighing platform.
– To raise the weighing platform, extend the leveling feet (turn clockwise).
– To lower the weighing platform, retract the leveling feet (turn counterclockwise).
– After leveling the weighing platform, tighten the lock nuts against the platform frame.
– Place the load plate on the platform