Festool RS 300 EQ Instrucciones De Servicio/Lista De Piezas De Repuesto página 8

Technical data
Power
Speed
Working strokes
Sanding stroke
Sanding shoe
Weight (excluding cable)
Degree of protection
The specifi ed illustrations can be found at the beginning of the operating instructions.
1 Intended use
As specifi ed, the machines are designed
for sanding wood, plastic, stone, composite
materials, paint/varnish, fi ller and similar
materials.
Metal and materials containing asbestos
must not be processed.
For reasons of electrical safety the machine
must not be damp nor operated in a humid
environment. The machine may only be
used for dry sanding.
The user is liable for damage and
injury resulting from incorrect usa-
ge!
2 Safety instructions
2.1 General Safety
Before using the machine, read all
safety instructions and these ope-
rating instructions carefully and
thoroughly.
Save all enclosed documents and pass the
machine with all these documents only.
2.2 Tool-specifi c safety rules
Always wear protective goggles
because of possible dangers when
sanding.
- The manufacturer's handling and proces-
sing instructions must be observed wit-
hout fail if explosive or self-igniting dusts
are likely to occur during sanding.
- Harmful/toxic dusts can occur during your
work (e.g. lead-containing paint, some
types of wood and metal). Contact with
these dusts, especially inhaling them, can
represent a hazard for operating person-
nel or persons in the vicinity. Comply with
the safety regulations that apply in your
country. Connect the electric power tool
to a suitable extraction system.
RS 300 EQ
280 W
4 000-10 000 rpm
8 000-20 000 rpm
2.4 mm
93 x 175 mm
2.3 kg
II
/
To protect your health, wear a P2
protective mask.
2.3 Noise and vibration informati-
on
The typical values determined in accor-
dance with EN 60745 are:
Sound-pressure level
Sound-power level
Measuring uncertainty allowance K = 4 dB
Wear ear protection!
Measured acceleration
3 Power supply and start-up
The mains voltage must correspond
to the specifi cation on the rating
plate.
Switch (1.1) serves as an On/Off switch
(I = On / 0 = Off). It may be latched with
the locking knob on the side (1.2) for conti-
nuous operation. Pressing the switch again
releases the lock.
Always switch the machine off be-
fore connecting or disconnecting the
mains lead!
See Fig. 3 for connection and disconnection
of the power cable.
4 Electronics
The RS 300 EQ has an electronic
control with which the rotational
speed can be varied step-free.
This allows the sanding speed to be adap-
ted to the optimum level according to the
material concerned (see Chapter 6).
The speed is set using the rotary control
button (2.1).
8
RS 300 Q
280 W
10 000 rpm
20 000 rpm
2.4 mm
93 x 175 mm
2.3 kg
II
/
76 dB(A)
87 dB(A)
5 m/s²