Mounting The Bar And Chain - Stihl MS 150 TC Manual De Instrucciones

English

Mounting the Bar and Chain

Disengaging the Chain Brake
Pull the hand guard towards the
N
front handle until there is an audible
click – the chain brake is
disengaged.
Removing the chain sprocket cover
2
1
Unscrew the nut (1) and remove the
N
sprocket cover (2).
22
Mounting the guide bar
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot.
3
4
Fit the guide bar over the stud (3)
N
and engage the peg of the tensioner
slide in the hole (4).
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
1
Fit chain around the sprocket (1)
N
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
2
Turn the tensioning screw (2)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
MS 150 TC