Chain Lubricant; Filling Chain Oil Tank - Stihl MS 150 TC Manual De Instrucciones

With the filler cap in the filling neck,
N
twist it counterclockwise until it
drops into its seat.
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position.
While pushing down on the cap,
N
twist the filler cap clockwise and
close it – see section "Closing."
MS 150 TC

Chain Lubricant

For automatic and reliable lubrication of
the chain and guide bar – use only an
environmentally compatible quality
chain and bar lubricant. Rapidly
biodegradable STIHL BioPlus is
recommended.
NOTICE
Biological chain oil must be resistant to
aging (e.g. STIHL BioPlus), since it will
otherwise quickly turn to resin. This
results in hard deposits that are difficult
to remove, especially in the area of the
chain drive and chain. It may even cause
the oil pump to seize.
The service life of the chain and guide
bar depends on the quality of the
lubricant. It is therefore essential to use
only a specially formulated chain
lubricant.
WARNING
Do not use waste oil. Renewed contact
with waste oil can cause skin cancer.
Moreover, waste oil is environmentally
harmful.
NOTICE
Waste oil does not have the necessary
lubricating properties and is unsuitable
for chain lubrication.

Filling Chain Oil Tank

Preparations
Thoroughly clean the oil filler cap
N
and the area around it to ensure that
no dirt falls into the tank.
Position the machine so that the
N
filler cap faces up.
Open the filler cap.
N
Filling up with chain oil
Refill the chain oil tank every time
N
you refuel.
Take care not to spill chain oil while
refilling and do not overfill the tank.
Closing the Tank Cap
N
There must still be a small amount of oil
in the oil tank when the fuel tank is
empty.
If the oil level in the tank does not go
down, the reason may be a fault in the oil
supply system: Check chain lubrication,
clean the oilways, contact your dealer
English
27