Imetec M3505 Instrucciones Para El Uso página 19

PROBLEM
The appliance does not go
on.
The appliance turns off
during use and does not
turn on again.
The vacuum cleaner does
not suction well..
The dust collection system
does not close correctly.
The vacuum cleaner
produces odours the first
few times it is used.
The brush remains too
close to the floor while
vacuuming.
The packaging of the appliance is made of recyclable materials. dispose of it in
accordance with the environmental protection regulations.
Pursuant to directive 2012/19/Eu on waste electrical and electronic equipment
(WEEE), the crossed bin symbol on the appliance or its packaging indicates that the
appliance must be disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for
electrical and electronic equipment. alternatively, instead of handling the disposal,
the user can hand over the appliance to the retailer when a new, equivalent one is
purchased. The user can hand over electronic products measuring less than 25 cm to
retailers of electronic products having a sales area of at least 400 m
with no obligation to buy. appropriate separate collection for the subsequent procedure for
the decommissioned appliance for recycling, which includes treatment and environmentally
friendly disposal helps prevent adverse effects on the environment and health and promotes
reusing and/or recycling materials that the appliance consists of.
TROUBLESHOOTING
• Ensure the power cord (14) is connected to the power socket.
• Ensure the ON/OFF switch (8) has been pressed [Fig. F1].
• The vacuum cleaner is equipped with a protective motor thermostat
that shuts off the appliance in the event of overheating! (caused by
obstructing objects or a clogged dust collection system).
• In the event of tripping, press the ON/OFF switch , unplug the power
cord (14) from the power socket and let the vacuum cleaner cool
down completely.
• remove any dust or the obstructing object before restarting the
appliance.
• Power regulator at a minimum, raise the suction power.
• The dust container (16E) is full: clean the container.
• The filters are clogged: clean or replace the filters.
• The safety interlock (16C) does not allow the dust collection system
to be inserted (16) if the HEPA premotor filter (16D) is absent.
• Make sure the HEPA premotor filter is present (16D) and it is fitted
correctly.
• These odours are harmless and disappear shortly afterwards.
ventilate the room.
• decrease the suction power by acting on the electronic power
regulator (7) or on the manual air flow regulation device (2).
DISPOSAL
SOLUTION
free of charge and
2
EN
17