Storing And Caring For The Product - Imetec M3505 Instrucciones Para El Uso

• Clean the dust collection system following the instructions below, paying attention to the
pictures in the illustrative guide.
• Fit the dust collection system (16) back onto the vacuum cleaner ensuring the position
lock clicks.
EN
CLEANING THE DUST CONTAINER (16E)
• Press the release button of the dust collection system (9) to extract the dust collection
system (16) from the appliance [Fig.G1].
• Press the upper cover opening/locking button (16B) to open the upper cover (16A) [Fig.
G2].
• Empty the container.
• Fit the upper cover back on (16A) ensuring the couplings with the dust container (16E) are
perfectly engaged and the upper cover opening/locking button (16B) is perfectly engaged
as well.
• Reinserire il sistema di raccolta polvere (16) sull'aspirapolvere avendo cura che scatti il
blocco posizione.
CLEANING OR REPLACING THE PREMOTOR HEPA FILTER (16D)
• Press the release button of the dust collection system (9) to extract the dust collection
system (16) from the appliance [Fig. G1].
• Remove the Hepa premotor filter (16D) from the dust collection system (16) [Fig. G3].
• If the Hepa premotor filter (16D) is obstructed by dust, remove the dust taking care not to
damage it.
• If the filter is especially dirty, replace it with a new one.
• Fit the HEPA premotor filter (16D) back onto the dust collection system (16) taking care to
push the frame until the top appendix closes the safety interlock (16C).
• Fit the dust collection system (16) onto the vacuum cleaner ensuring the position lock
clicks.
CLEANING OR REPLACING THE OUTLET FILTER (16)
• Press the release/locking button of the outlet filter grid (20) to remove the outlet filter grid
(19).
• Extract the outlet filter (18) [Fig. G4].
• If the outlet filter (18) is obstructed by dust, remove the dust taking care not to damage it.
• If the filter is especially dirty, replace it with a new one.
• Refit the outlet filter (18) in the appliance [Fig. G4].
• Fit the outlet filter grid back on (19) and click the coupling/locking button of the outlet filter
grid in position (20).

STORING AND CARING FOR THE PRODUCT

The flexible suction pipe (5) can be disconnected from the appliance before putting it away. To
this end, press the locking buttons of the flexible suction pipe (6) and disconnect the flexible
suction pipe (5).
The suction pipe (3) with the combined brush (4) may be stored by hooking them to the
appliance with the suitable couplings (12 or 17); the relative pictures in the illustrative guide are
marked with the parking symbol [Fig. F2, F3].
16