RIB Super 3600 Guia De Instalacion página 29

A - CONNEXIONS
J1 EXP. Connector for EXPANDER card
J2 SEC.TRANSF. Connector for secondary transformer
J3 L 1 - N Power supply 230 Vac 50/60 Hz (on request
120V/60Hz)
PRI.TRANSF.
J4 Connector for primary transformer
J5 DO NOT TOUCH THE JUMPER ! IF IT IS
REMOVED THE OPERATOR DOESN'T MOVE !
SEC.LOCK
J6 Not available
J7 ENCODER Not available
CAPACITOR
J8 Connector to the capacitor
J9 Connector for limit switch connection
LSO
Limit switch contact stopping the motor opening
COM. Contacts common unit
LSC
Limit switch contact stopping the motor closing
J10 MOTOR Connector to the Motor
U = BLUE wire (common)
N.B.: The fuse F2 is a 15A fuse (only for
SUPER3600).
J11 Blinker (max. 40W )
J12 AERIAL Radio Antenna
COM
Contacts common unit
PHOT.1 NC
Photocells contact (NC)
INVERTER
J13 Not available
J14 STOP Contact of the stop button (NC)
OPEN
Contact of the opening button (NO)
CLOSE
Contact of the closing button (NO)
K BUTT. Contact of a single impulse (NO)
A*A
24 Vac accessories power supply
SIGNAL
Warning light - gate open 12Vdc
BUZZER Wiring acoustic warning (12Vdc max 200 mA)
RADIO
J15 Connector for radio receiver 24Vac
HEATER
J16 Connector for Heater Card
J17 INVERTER DO NOT ALTER THE SAFETY DEVICE !
TRIMMER
R2 WITH SUPER 3600 IS DISABLED
LOW SPEED
TRIMMER
R9 To adjust the force of the operator through
TORQUE the electronic clutch
G G
B B