Kärcher CV 36/2 Manual De Instrucciones página 7

Note: We recommend using our microfilter mounting kit in addition
to the paper filter bag (Order no. see 4. Accessories). BIA category
C, Filtration efficiency always higher than 99.9%. It allows particular-
ly fine dusts to be sucked off which are damaging to health. The
micro filter should be changed when the suction performance is
insufficient even after new paper filter bags have been fitted.
3.1 Connect the upper section of the vacuum
cleaner to the brush head
Unscrew both fastening screws from the upper section of the
vacuum cleaner before assembly.
Push the upper section of the vacuum cleaner upright onto the
brush head. Then insert the two aluminium sections into the
grooves provided on the upper section of the vacuum cleaner.
Fasten with screws. Tighten screws firmly. <Figure 2>
Connect the hose to the brush head and upper section of vacuum
cleaner. Plug the connecting cable with connector into the socket
on the upper section (connector must slot home). <Figure 3>
3.2 Storing and removing cable
The vacuum cleaner's power cable can be wounded up around
the upper and lower cable clips. The entire cable can be easily
removed by turning the lower cable clip.
3.3 On and off positions
The brush head has a pivot latch which locks the unit in the
upright off position. To operate, tread on the latched pedal and
tip the vacuum cleaner backwards. <Figure 4>
Caution: do not drive the rotating brushes over the connecting
cable. Carry the unit over steps and high thresholds.
3.4 Working with the hand pipe <Figure 5>
Switch the unit on via the ON/OFF switch
Please note: The carpet brush switches on automatically once the
hand pipe with handle is firmly located in the motor housing. Please
check.
If the hand pipe with handle is pulled out of the motor housing
for vacuuming, the carpet brush switches off automatically.
The suction hose's elasticity means that the effective working
radius can be increased.
The crevice and upholstery nozzle can be attached to the end of
hand pipe.
Important: Never use the hand pipe for vacuuming without first
attaching either the crevice nozzle or the upholstery nozzle (the
cleaner will malfunction if the end of the hand pipe is worn down –
see Section 6 for Troubleshooting).
The hand pipe is pushed upright into the motor housing.
3. Starting the unit and handling
Figure 2
Figure 3
Figure 4
Figure 5
English
7