Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 Exchanging the paper filter bag <Figure 7>
•
Depress the cover fastener and remove cover.
•
Push the filter bag catch to the left until it is possible to pull
the filter bag off the connection piece.
Assembly:
•
Insert the narrow end of the support card into the holder.
•
Push the filter bag catch to the left and guide the support
card upwards over the connection piece until it slots in.
•
Replace the cover.
Please note: If the cover does not close, check whether the filter bag
has been inserted properly.
5.2 Exchanging the safety filter <Figure 8>
After exchanging the filter bag approximately 20 times, exchange
safety filter.
•
Press cover fastener and remove cover.
•
Lift the red locking device and pull out the safety filter.
Assembly:
•
Lift the red locking device and insert the safety filter.
Please note: If the cover does not close, check whether the filter bag
has been inserted properly.
5.3 Exchanging the exhaust filter <Figure 9>
After exchanging the filter bag approximately 20 times, exchange
the exhaust filter.
•
Push the exhaust filter off the housing and withdraw.
Assembly:
•
Insert new filter.
5.4 Exchanging the brush strip <Figure 10>
•
Unscrew the brush head cover. Turn the brush so that the
brush strip can be pushed or pulled through the opening.
Assembly:
•
Push home the new brush strip and screw the cover on
again.
5. Care and maintenance
Figure 7
Figure 8
Figure 9
Figure 10
English
9
Publicidad
Tabla de contenido
