Din Radio Provision With Pocket; Touch Screen; Home Screen; Sync Screen - Metra 99-5826CH Instrucciones De Instalación

Kit Assembly
Double DIN radio provision
1. Cut and remove the center bar from the
radio housing. (Figure A)
2. Snap the double DIN brackets to the inside
edge of the radio housing. (Figure B)
3. Slide the radio into the radio housing
assembly and secure to the assembly
using the screws supplied with the
radio. (Figure C)
4. Snap the double DIN trim plate into the
radio housing.
5. Connect the climate extension harness
to the climate control harness removed
in step 2 of disassembly, and then into
the 99-5826CH radio/climate housing
panel.
6. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapters from Metra and
AXXESS to integrate your new radio. Re-
connect the negative battery terminal
and test the radio for proper operation.
7. Reassemble the dash in reverse order
of disassembly using the 99-5826CH
radio/climate panel instead of the
factory radio trim panel.
(Figure A)
(Figure B)
(Figure C)

Home Screen

1. Takes you to the SYNC
information screen.
2. Takes you to the tools screen.
3. Takes you to the climate
control screen.

SYNC Screen

• Any time you press the SYNC
button (icon 2) it will take
you to the SYNC information
screen. This screen will show
USB text and satellite text
(if equipped).
• The following screen
shows the SYNC information
that is coming from your
vehicle. If you would like to exit
this screen press the home
button located on the bottom
of the screen.
4

Touch Screen

3 1
(if SYNC is equipped)
2