Kit Assembly - Metra 99-5831 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Secure the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips screws
supplied. (Figure A)
2. Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
3. Slide the radio into the bracket/pocket
assembly, then secure the radio using the
screws supplied with the radio. (Figure B)
4. Snap the hazard switch into the radio
trim panel from the front.
5. Snap the A/C vents into the radio trim
panel from the back.
6. Plug in the passenger airbag light and
hazard connections.
7. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS .
8. Attach (4) panel clips to the radio trim
panel, then reassemble the dash in
reverse order of disassembly, using the
99-5831 radio trim panel.

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DDIN radio provision
1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Snap the hazard switch into the radio
trim panel from the front.
3. Snap the A/C vents into the radio trim
panel from the back.
4. Plug in the passenger airbag light and
hazard connections.
5. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS.
6. Attach (4) panel clips to the radio trim
panel, then reassemble the dash in
reverse order of disassembly, using the
99-5831 radio trim panel.
(Figure A)
REV. 2/26/2019 INST99-5831
3