Kit Assembly - Metra 99-5825 Instrucciones De Instalación

1. Snap the factory vents into the
radio panel. (Figure A)
2. Mount the ISO brackets to the
head unit with the screws supplied
with the unit. (Figure B)
(Figure A)

Kit Assembly

3. Mount the radio bracket assembly
to the radio panel using the
supplied screws. (Figure C)
4. Mount the factory airbag indicator
to the Radio Panel using the
supplied screws. (Figure A)
99-5825
5. Locate the factory wiring
harness and antenna plug in the
dash. Metra recommends using
the proper mating adapters from
Metra and/or AXXESS.
6. Reassemble dash in reverse order
of disassembly.
NOTE: This kit comes pre-programmed
for vehicles equipped with SYNC. It
will not operate properly in vehicles
equipped without SYNC unless it is
programmed.
Programming for vehicles
without SYNC:
1. Turn on the ignition.
2. Press and hold the kit's menu
button for ten seconds.
3. Release the menu button and test
the kit's buttons for proper
operation.
3
(Figure A)
(Figure C)