Cleaning, Maintenance And Storage; Cleaning Instructions; Maintenance And Service; Storage - MSA R512539 Instrucciones De Uso

Cleaning, Maintenance and Storage

4 Cleaning, Maintenance and Storage
4.1

Cleaning Instructions

Clean the components with a solution of water and mild laundry detergent. Do not immerse the components
in water. Dry hardware with a clean cloth and hang to air dry. Do not speed dry with heat. Excessive accu-
mulation of dirt, paint or other foreign matter may prevent proper function of the components, and, in severe
cases can weaken them. Questions concerning component conditions and cleaning should be directed to
MSA.
4.2

Maintenance and Service

Equipment which is damaged or in need of maintenance must be tagged as "UNUSABLE" and removed
from service. Corrective maintenance (other than cleaning) and repair, such as replacement of elements,
must be performed by the MSA factory. Do not attempt field repairs.
The moving parts of snaphooks and carabiners may require periodic lubrication. Use a lightweight low
viscosity penetrant oil that has good resistance to temperature extremes, moisture, and corrosion. Do not
over-lubricate. Wipe off excess oil with a clean, dry cloth. Follow the lubricant manufacturer's instructions.
4.3

Storage

Store the rope grab subsystem in a cool, dry and clean place out of direct sunlight. Avoid areas where heat,
moisture, light, oil, and chemicals (or their vapors) or other degrading elements may be present. Equipment
which is damaged or in need of maintenance should not be stored in the same area as usable equipment.
Heavily soiled, wet, or otherwise contaminated equipment should be properly maintained (e.g. dried and
cleaned) prior to storage. Prior to using equipment which has been stored for long periods of time, a Formal
Inspection should be performed by a competent person.
US
16 Rope Grab Subsystem