Forward-Facing Installation With Latch - Graco ComfortSport Manual De Instrucciones

FORWARD-FACING
1
LATCH belt must be routed through
opening in car seat for
(see page 23, fig. k).
Belt must lay flat and not be twisted.
2
Adjust car seat to upright position (see pages 18
and 19, fig. b) and place
vehicle seat equipped with
3
For ease of installation, extend
to its maximum length.
4
Hook connectors to vehicle lower anchors
(fig. a). Pull connectors to be sure they are
securely attached (fig. b).
5
Press down firmly in center of car seat to
compress vehicle seat cushion while tightening
LATCH belt by pulling adjustment belt (fig. c).
Use your knee to press down in center of
car seat (fig. c).
10
INSTALLATION WITH
forward-facing
forward-facing on
LATCH anchors.
LATCH belt
6
Pull front to back and left to right to check for
secure installation (fig. d).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service
(see back cover).
Attach tether strap hook (A) to anchor
7
hardware (B) and tighten adjustment belt to
remove any slack (fig. e).
Periodically check that car seat is securely
installed; adjust if necessary.
LATCH