Programming - SKF TLMP 1008 Instrucciones De Montaje

6. Assembly

6.7 Programming

To program TLMP 1008 pumps proceed
according to the following programming
scheme.
Simultaneously press key 3.2 and key 3.3 for
about 4 seconds to access the first program-
ming step P1. After releasing the keys the
adjusted value will be displayed. Change the
value of the programming step by pressing
key 3.3.
Confirm adjusted value within 30 seconds
by pressing key 3.2. Otherwise the value will
be lost.
Programming is continued with program-
ming step P2. After confirming the last step
P6 the programming is completed.
Programming steps
P1 Setting of the pause time in hours
P2 Setting of the pause time in minutes
P3 Setting of the metering device cycles
P4 Setting of the output signal on the moni-
toring relay
P5 Setting of the differentiation between
fault and low-level signal.
P6 Setting of the start stage
A = Programming step
B = Possible value
C = Change value by pressing the key
D = Possible new value
E = Confirm adjusted value within 30
seconds by pressing key 3.2 and continue
with the next programming step. Confirm
and finish the programming by pressing
key 3.3 after the last programming step.
3.3 3.2 A
&
On
min h
> 4 S
On
min
h
On
min
h
On
min
h
On
min h
On
min h
Notes related to the programming
Settings can be done in one direction only (+)
Fast forward by holding down key 3.3.
B C D
On On
min h min h
On On
min min
h h
On On
min min
h h
On On
min min
h h
On On
min h min h
On On
min h min h
EN
Programming scheme Fig. 10
E
3.3
On
min h
39
6