SKF TLMP 1008 Instrucciones De Montaje página 297

EN EN
Residual risk
Bursting reservoir if filled by a high-
performance pump
Contact with stirring paddle during
"test operation" without reservoir after
repair.
Contamination of the environment
with lubricant and wetted parts
Strong heating of the motor
due to a blockade
Damage of the control pcb due to
electrostatic discharge when replacing
a defective membrane keypad
Loss of electrical protective functions
due to fault assembly of the control
pcb due to faulty assembly of the
control pcb
Life cycles:
A = transport, B = installation, C = initial start-up, D = operation, E = cleaning, F = maintenance, G = fault, repair, H = shutdown, K = disposal
16
Possible in life cycle Prevention/ remedy
Monitor the filling procedure and stop it when reaching the max marking of the
C D
reservoir
G Operate pump with reservoir always
C D F G K Dispose of the parts following the relevant legal/ operational regulations
C D Switch pump off, let parts cool down, eliminate cause.
Avoid electrostatic charge. Use ESD tools and ESD protective clothes, wear a
G
grounding bracelet
After the installation carry out a safety check following DIN EN 60204-1 (con-
G
duct and scope of test, see Service instructions 951-151-000)
1. Safety instructions