Operating Panel - Pando PGA-4130 Manual De Instrucciones

ATTENTION:
Before performing any works on cleaning,
disconnect the product from the gas network
and the mains.

2) OPERATING PANEL

In order the glass surface keeps shine, it shall be
washed with warm water with soap after each use,
rinsed and dried. Moreover, it is necessary to wash
enamelled grates, enamelled caps "A", "B" and "C"
and gas ring heads (refer to Fig. 6-7) and clean
ignition plugs "A" and thermocouple probes "TC" (refer
to Fig. 6). It is prohibited to wash all these parts in
dishwashing machine.
Cleaning shall be performed carefully with small nylon
brush, as shown in the Figure (refer to Fig. 8) and the
product shall be left till complete drying. Cleaning shall
be performed after complete cooling of cooktop and
its components, it is prohibited to use metallic
sponges, abrasive powders or sprays causing
corrosion.
It is necessary to exclude long-term contact of the
surface with such products as vinegar, coffee, milk,
salt water or lemon or tomato juice.
FIG. 6/B
FIG. 6
CLEANING
WARNING:
When arranging cooktop components in their
places, it is necessary to observe the following
recommendations:
- Make sure that slits of gas ring heads "T" (Fig.
6/А) are not blocked with foreign articles.
- Make sure that enamelled caps "A", "B", "C"
(Fig. 6-7) are correctly installed on the gas ring
heads. In the correct position the cap installed
on the head shall be completely stable.
- If any tap is opened and closed hardly, don't
apply force: immediately contact with the
technical support service.
- Grates shall be installed on the appropriate
centering pins (or on aluminium shape, if any).
Make sure in complete stability.
- It is prohibited to use steam jet when cleaning
the product.
FIG. 7
8
FIG. 8