Pando PGA-4130 Manual De Instrucciones página 70

TECHNICAL INFORMATION FOR
PERSONNEL BEING RESPONSIBLE
FOR INSTALLATION
Only qualified people can perform installation, any
regulations, modifications and operations on
maintenance, which are described in this chapter.
The manufacturer can't be considered to be
responsible for damage, which can be caused to
the persons, animals or property as a result of
incorrect installation of the product.
Within the product service life, changes in the devices,
which ensure safety or automatic regulation of
equipment, can be made by the manufacturer or its
properly authorized supplier.
3) COOKTOP BUILDING IN
Remove outer package and inner packages of all
movable components, make sure that the cooktop is in
serviceable condition. If the product condition raises
doubt, the product operation shall be prohibited, it is
necessary to contact with the qualified personnel.
Package elements
polystyrene, nails...) shall be keep out from
children, as they represent sources of potential
hazard.
For cooktop building in, opening with sizes given in
Figure 9 shall be cut out on the countertop of your
furniture and it is necessary to make sure in strict
observance of the limit distances within the area,
where the product will be installed (refer to Fig.
The equipment belongs to the products of the 3
class, thus it shall meet all the requirements
specified in the standards, which cover the
indicated products.
The installer shall consider that the product can be
installed only with one side wall (from the right or from
the left of the cooktop), which height shall be higher
than the level of the cooktop and which shall be located
observing the minimum distance, which is indicated in
the Table given below.
INSTALLATION
(cardboard, bags,
FIG. 11
4) COOKTOP FASTENING
The cooktop is equipped with special gasket, which
excludes any leakage of liquid inside the
correct installation of this gasket, the following
instructions shall be strictly observed:
- Remove moving parts of the cooktop.
- Cut the gasket into 4 parts with the required length in
order to install them on 4 edges of the glass surface.
- Turn over the cooktop and correctly arrange
adhesive surface of gasket "Е" (Fig. 11) under the
cooktop edge so that external edge of the gasket
aligns with the cooktop perimeter edge. External
edges of the strips shall mate without overlapping.
- Attach the gasket to the glass uniformly and reliably
pressing with
- Install the cooktop into the opening made in the
furniture and secure it with screws "F" using fastening
hooks "G" (refer to Fig. 12).
- In order to exclude possible accidental contacts with
the surface of cooktop casing, which is highly heated
during operation, wood pad shall be placed at a
distance of at least 70 mm from the countertop and
foam
fixed with screws (Fig. 9).
- To fix the product on the supporting structure, it is not
recommended to use electrical electric screwdrivers,
fastening hooks shall be tightened manually with
average force.
10).
10
fingers.
FIG. 12
furniture. For