Pando PGA-4130 Manual De Instrucciones página 79

PROBLEM
The gas ring burns
unevenly
Gas ring flame suddenly
changes / flashes
Flame is ignited with a great
delay.
Flame foes out immediately
after ignition
Change in colour of grates
within burning area.
When pressing the control
knob flame is not ignited
(the spark plugs emit spark)
When pressing the control
knob flame is not ignited
(the spark plugs don't emit
spark)
Electric ignition doesn't
operate.
The spark plugs constantly
emit spark.
USER SOLUTIONS
CAUSE
Contamination inside the gas ring
head.
Wrong gas regulation
Wrong assembly of
components.
Wrong assembly of
components.
Ignition handle was released too
early.
Problem with thermocouple
Normal situation caused by high
temperature or contamination.
Gas absence or presence of residuals
of contamination or cleaning agent on
the spark plugs
Problems with plug or with ignition.
Power supply absence.
Wrong assembly or ignition failure.
Humidity
Wrong assembly or fault of micro
switch
SOLUTION
Remove foreign articles from gas ring head.
Contact with official technical support service of
Pando.
gas ring
Correctly install the gas ring components.
gas ring
Correctly install the gas ring components.
Hold the handle pressed within longer period of
time and before finally releasing it, strongly
press it.
Move thermocouple
Contact with official technical support service of
Pando.
Clean grates and components of gas ring using
the appropriate metal cleaning agents
Open the gas valve meter; clean the spark
plugs as described in chapter "Cleaning"
Contact with official technical support service of
Pando.
Make sure
connected with the mains. Check, weather the
meter is turn on.
Contact with official technical support service of
Pando.
Power off for 24 hours and give the top part to
dry; Make sure that all bushings are installed
correctly.
Contact with official technical support service of
Pando.
that electrical connector is