Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8) POWER SUPPLY
IMPORTANT: installation shall be performed
according to the manufacturer's instructions.
Errors during installation can be a cause of
damage made to people, animals or property, for
which the manufacturer can't be responsible.
Connection to the mains shall be performed
observing the applicable standards and provisions
of the legislation.
- Specifications of supply voltage and power are
indicated on the labels from the inner side of the
product, they shall be observed when choosing the
appropriate cable section for connection with the
mains.
- Before energizing make sure that connector or
installation are equipped with the reliable grounding
according to the currently applicable standards and
provisions.
The
responsible in case of non-fulfilment of these
provisions.
When connecting with the mains via socket:
- If plug connector is not provided for power cable "C"
(refer to Fig. 13), install standard plug connector
corresponding to the load, which is indicated on the
label. Connect the cable according to the diagram in
Fig. 13, carefully observe the following conditions:
Letter L (phase) = brown cable;
Letter N (zero) = blue cable;
Grounding symbol
- The power cable shall be installed so that it is never
heated to the temperature of 90°C in any point.
When connecting, don't use changers, adapters or
-
taps, as they can be a cause of reliable contacts and
hazardous
overheating.
-
Upon cut-in completion, access shall be ensured to
the plug
connector.
When connecting directly to the mains:
-
According to the applicable standards, install a single
pole circuit-breaker between the product and the
mains, which size shall meet the product
Remember that grounding cable can't be interrupted
-
by the circuit breaker installation.
-
It is strongly recommended to connect yellow-green
grounding cable to the reliable grounding installation.
INSTALLATION
manufacturer
shall
= green and yellow cable.
load.
To ensure greater safety, connection to the mains can
also be protected with differential circuit breaker with
sharp
response.
Before starting any works with the product
electrical part, is shall be completely disconnected
from the mains.
If it is necessary to make changes in the domestic
mains for installation or if incompatibility between
socket or plug connector of the product is
detected, then such works shall be performed by
the
professional
Professional electrician shall make sure that
among other issues the plug connector cable
cross
section
consumed by the product.
not
be
WARNING:
The whole our products correspond to the
European
amendment to them. Thus, this product meets the
requirements of the applicable EU directives
belonging to the following:
- electromagnetic compatibility (EMC);
- electrical safety (LVD);
- restriction
substances (RoHS);
- ecodesign (ERP)
13
competent
corresponds
Standards
and
the
on
use
of
some
personnel.
to
the
power
appropriate
hazardous
FIG. 13
Publicidad
Tabla de contenido
