Ceramic-Glass - Pando PGA-4130 Manual De Instrucciones

ATTENTION:
Before each cleaning it is necessary to disconnect
the product from the gas network or the mains.

Ceramic-Glass

In order to maintain shine for ceramic-glass
surface, it is recommended to treat the glass
surface with substance on the basis of silicon
before operation commencement to create a film,
which ensures protection
contamination. This protective film is nondurable,
thus, treatment shall often be repeated with use of
such a substance.
It is very important always clean the glass after
use, till it is warm.
When cleaning never use metallic sponges,
abrasive products and sprays, which cause
corrosion.
1F (30)
WALL
CLEANING
from water and
SIZES, WHICH SHALL BE MET (mm)
A B C
282 482 59
WALL
FIG. 9
Considering contamination degree, you should
remember that:
- Small contaminations can be removed by
means of soft sponge.
- Resistant and hardened contaminations can be
easily removed by means of scraper (Fig. 6/В),
which is not included into the cooktop delivery
set, but which can freely be purchased in the
local network. Use the scraper carefully not to
injure.
- Remaining liquid having spilled from the pans
shall be removed with vinegar or lemon.
- Be careful,
containing sugar getting on the cooktop during
cooking. If it occurs, turn off the cooktop and
immediately remove spots, until they cool, with
warm water and scrapper.
- At insufficient cleaning of the cooktop or
incorrect cookware handling, in course of time
colour spots, metal glares or strips can occur
on the cooktop. Though it is difficult to remove
them, these strips are not a sign of failure in the
cooktop operation.
- It is prohibited to use steam jet when cleaning
the product.
D E
59 300 min.
FIG. 10
9
prevent sugar or
F
Min 70 mm
products