Display Indications - Alliance Laundry Systems S Serie Instrucciones De Funcionamiento Y Programacion

The following table lists the various displays
and what they mean. The operator should
become familiar with these computer displays.
Display Meaning
Program identification code (ROM)
S04
This is an example only.
Hold Wait...power has just been turned on.
CY Cycle (followed by two-digit number)
CHEC/CYC* Test cycle selected.
FAr Degrees Fahrenheit
CEL Degrees Celsius
PrE Prewash segment (1st of 8 segments)
UASH Wash segment (2nd of 8 segments)
FIL1 First rinse (3rd of 8 segments)
FIL2 Second rinse (4th of 8 segments)
FIL3 Third rinse (5th of 8 segments)
FIL4 Fourth rinse (6th of 8 segments)
FIL5 Fifth rinse (7th of 8 segments)
FIL6 Sixth rinse (8th of 8 segments)
SRIN Spray rinse
dRIN Dilution rinse
PrEU Normal prewash selected.
Reads "SPIn" for one second, then
SPIn/tInE*
"tInE" followed by time for spin.
Temperature sensor failure or temperature
tSFL
out of range.
*Display indications separated by a slash represent an alternating display.
F232087

Display Indications

Display
FLUS
CFIL
bFIL
HFIL
LOLE
HILE
SUP1
SUP2
SUP3
SUP4
SUP5
SUP6
SUP7
StOP
SdLY
donE
door
FILL/StOP*
FULL
Operation
Meaning
Overflow prewash selected.
Cold fill
Warm fill (both hot and cold)
Hot fill
Low water level
High water level
Supply 1
Supply 2
Supply 3
Supply 4
Supply 5 (supply 1 and 2)
Supply 6 (supply 2 and 3)
Supply 7 (supply 3 and 4)
Stop routine
Spin coast delay
Cycle and stop routine have ended.
Door not properly closed.
Programmed water level not reached after
30 minutes.
The computer detects low water level or
higher when none should be present.
15