Ega Master 79612 Manual De Instrucciones página 30

SAFETY INSTRUCTIONS FOR PREVENTION OF WORKPLACE HAZARDS
instructions booklet:
slippery surface, hoses, cables).
well. Observe the following:
hold the machine firmly and safely by hand.
has to be stopped instantly. It only may be re-started after having eliminated the
cause for the fault.
sparks.
before work is started. Among others, this relates to dust deposits, cardboard,
packing material, textile, wood and wooden splints, but also flammable fluids and
gas.
Make sure there is adequate lighting. Be extra careful in unfamiliar surroundings. There is a
risk of hidden hazards such as electric lines or other supply lines. Make sure when operating the
machine that no electrical cables, gas pipes or similar could be damaged. Use suitable and personal
30
WARNING
The following applies unless otherwise stated in the machine's operating
The machine is not insulated to protect against an electrical power surge.
CAUTION – risk of injury!
Hands may be crushed, seized or otherwise injured.
Keep your hands away from areas which are marked with this symbol.
CAUTION – risk of injury!
Remove all sources of danger which could lead to slipping, tripping or falling (e.g.
Keep the work area clean and dry.
PROHIBITION – Eating, drinking and smoking are forbidden during operation.
WARNING – Explosion hazard!
Operate the machine according to the intended use only.
The machine is designed for the use in areas exposed to explosion hazards as
• Valid local explosion protection directives.
• Technical specifidation of the machine.
• Markings on the machine.
• Avoid the generation of sparks.
• When operating the machine, do not push or beat against other material and
• Do not slide the machine over the ground.
• If heat generation exceeds the specified surface temperature, the machine
• The work area and the next working areas should always be protected from
• Flammable and explosible material has to be removed from the work area
protective equipment.